Customer
Shopping Cart

HoldFast Gear Money Maker Original Leather Camera Harness - Bridle Black - Large

Manufacturer:
HoldFast Gear
Our Part Number:
HFG1016
Manufacturer Part No:
MM06-BK-L
Backorder
Ship Time: Please LiveChat or Email For Time
Quick Overview
- Legendary MoneyMaker in leather
- Anchored stainless steel d-rings/hardware
- Safety straps for ultimate security and impeccably versatile
- Everything you need to shoot with two cameras
$230.00
HoldFast Gear Money Maker Original Leather Camera Harness - Bridle Black - Large HoldFast Gear Money Maker Original Leather Camera Harness - Bridle Black - Large HoldFast Gear Money Maker Original Leather Camera Harness - Bridle Black - Large HoldFast Gear Money Maker Original Leather Camera Harness - Bridle Black - Large HoldFast Gear Money Maker Original Leather Camera Harness - Bridle Black - Large
HoldFast Gear Money Maker Original Leather Camera Harness - Bridle Black - Large

The Bridle leather MoneyMaker is made from U.S. native steer hides, anchored stainless steel d-rings/hardware (no rust), safety straps for ultimate security and impeccably versatile design make this an essential tool for the modern photographer. The Water Buffalo leather hide is characterized by a pliable, full bodied hide fully vegetable tanned.

The Money Maker is built to last a lifetime and on all day shoots in any location—a movie set, wedding, urban jungle, or the wild wild west. EVERY MONEYMAKER IS MADE LOCALLY, RIGHT HERE IN OKLAHOMA!

Each MoneyMaker comes with EVERYTHING you need to shoot with two cameras including Sliders, safety catches & 2 Camera HoldFasts. Directions: 1. Install the Camera HoldFast (screw) into the tripod mount of your camera. 2. Install the split ring from the Safety Catch directly to the left side lug of your camera. 3. Attach the Sailboat clip (on the MoneyMaker Slider) to the screw loop, then attach the Safety Catch clip to the previously installed split ring on the left side. 4. Please refer to our videos page for more details and explanations.

Size & Fit
Original MoneyMaker is 1-1/2" wide.

Fit is based on HEIGHT & BROADNESS. The ideal carrying position of the MoneyMaker is for the strap to fall about 4" below the armpit so the cameras stay high on the body.

SMALL= Height of 5'7" (170 cm) and below (if you are broad/built then size up)

MEDIUM= Height between 5'8"-6'2" (173 - 188 cm) (if you are slender then size down, broad or built size up)

LARGE= Height of 6'3" (191 cm) and above OR wear extra large clothing (if you are slender then size down)

Ideally, you want the straps of the MM to fall about 4-5" below the arm pits. Optimum fit will ensure the most comfort long term. If the MoneyMaker is worn too loose it causes the cameras to swing and sway too much, which puts pressure on your lower back while at the same time the straps will tend to move and slip more. When worn properly, the MoneyMaker will be anchored to the body and actually help to correct poor shooting posture by pulling your shoulders upright and back, keeping you and your cameras in line. So when the main straps are around 4” below the arm pit area, this in most cases will place the clip that attaches to the camera right around your waist line. So there should be a good amount of arm bend when your hand is on the camera at resting position and this is what you want!

CA Proposition 65

Attention to all California residents, Proposition 65 or officially known as, the Safe Drinking Water and Toxic Enforcement Act of 1986, is a law that requires warnings be provided to California consumers when they might be exposed to chemicals identified by California as causing cancer or reproductive toxicity. The warnings are intended to help California consumers make informed decisions about their exposures to these chemicals from the products they use. The California Office of Environmental Health Hazard Assessment (OEHHA) administers the Proposition 65 program and publishes the listed chemicals, which includes more than 850 chemicals. August 2016, OEHHA adopted new regulations, to go into effect on August 30, 2018, which changes the information that is required in or on Proposition 65 warnings.

We want you to know and be aware of our product safety and Midwest Photo is taking all of the necessary steps to comply with the applicable safety and health requirements made by this Proposition 65.

WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

This disclaimer can be found on the product pages on our website under the Additional Information tab which appears below the product description. It is listed on all product pages to ensure that our customer is aware of the warnings put out by our suppliers so you can know the precautions before purchasing. 

Additional Information about Proposition 65

For background on the new Proposition 65 warnings, see https://www.p65warnings.ca.gov/new-proposition-65-warnings.

Proposition 65 and its regulations are posted at https://oehha.ca.gov/proposition-65/law/proposition-65-law-and-regulations.

To give Midwest Photo any notices of an alleged violation of the California Health and Safety Code Section 25249.5 or 25249.6, you must send us a notice at mpex@mpex.com.