Customer
Shopping Cart

Ilford Pop Up Darkroom

Manufacturer:
Ilford
Our Part Number:
ILF1499
Manufacturer Part No:
1181926
Backorder
Ship Time: Please LiveChat or Email For Time
Quick Overview
- Ilford Pop Up Darkroom
$325.00
Ilford Pop Up Darkroom Ilford Pop Up Darkroom Ilford Pop Up Darkroom
Ilford Pop Up Darkroom
This simple guide will show you how easy it is to erect your ILFORD Pop Up Darkroom.

Before assembling ensure that you have sufficient floor space and height:- The external metal frame is approximately 2.2m tall and the internal space is 1.3 x 1.3m. If you are choosing to attach a fan / air blower to the lower vent on your pop up darkroom then this will cause it to expand slightly.
  • Open the storage case and remove the poles, groundsheet and pop up darkroom.
  • Move the groundsheet out of the way for now and unfold the pop up darkroom so that the black plastic cross is roughly in the centre
  • Unfold the poles and clip the 1st three sections on each together
  • Push the top of each pole into one of sections on the plastic cross - Repeat for all 4 poles.
  • Attach the 1st two clips onto each pole
  • Erect each pole fully and attach remaining clips.
  • Fold out the skirts so they lie flat to the floor.
  • Insert the pegs into the bottom of each pole.
  • Roll up the front of the pop up darkroom and use toggles to hold it in place.
  • Attach the groundsheet inside the pop up darkroom using the velcro.

A durable light tight black material clips to the frame while an accompanying ground mat offers protection for your flooring. This and can be fastened to the interior skirt of the darkroom.

A built-in air vent towards the base allows for an optional fan / air blower to be used. Once sealed, the incoming air will expand the inner dimensions. A smaller vent is also included closer to the top of the darkroom to attach air extraction tubes (not included).

*products shown inside darkroom for reference only and are not supplied with the pop up darkroom. Find out more about them below.

CA Proposition 65

Attention to all California residents, Proposition 65 or officially known as, the Safe Drinking Water and Toxic Enforcement Act of 1986, is a law that requires warnings be provided to California consumers when they might be exposed to chemicals identified by California as causing cancer or reproductive toxicity. The warnings are intended to help California consumers make informed decisions about their exposures to these chemicals from the products they use. The California Office of Environmental Health Hazard Assessment (OEHHA) administers the Proposition 65 program and publishes the listed chemicals, which includes more than 850 chemicals. August 2016, OEHHA adopted new regulations, to go into effect on August 30, 2018, which changes the information that is required in or on Proposition 65 warnings.

We want you to know and be aware of our product safety and Midwest Photo is taking all of the necessary steps to comply with the applicable safety and health requirements made by this Proposition 65.

WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

This disclaimer can be found on the product pages on our website under the Additional Information tab which appears below the product description. It is listed on all product pages to ensure that our customer is aware of the warnings put out by our suppliers so you can know the precautions before purchasing. 

Additional Information about Proposition 65

For background on the new Proposition 65 warnings, see https://www.p65warnings.ca.gov/new-proposition-65-warnings.

Proposition 65 and its regulations are posted at https://oehha.ca.gov/proposition-65/law/proposition-65-law-and-regulations.

To give Midwest Photo any notices of an alleged violation of the California Health and Safety Code Section 25249.5 or 25249.6, you must send us a notice at mpex@mpex.com.