CM-N3-ACC Remote Cable

For remotely triggering the electronic shutter release of Canon cameras equipped with a N3 Remote Terminal.

Features:

• Cable length: 3' (91.5 cm)
• From 1/8" (3.5 mm) Stereo Miniphone To Canon N3
• Compatible with cameras using a Nikon 10-pin Remote Terminal including:
  • Canon- EOS-1D Mark III, EOS-1D Mark II N, EOS-1Ds Mark III, EOS D2000, EOS-1Ds Mark II, EOS-1D Mark II, EOS D30, EOS D60, EOS 5D, EOS 10D, EOS-1V HS, EOS-3,EOS 20D, EOS 30D, EOS 40D, EOS-1D, EOS-1Ds, EOS-1V
  • Kodak-DCS 560, DCS 520
    Not for use with DCS Pro SLR/c

ACC Cables are a special kind of Pre-Trigger cable for use with the new FlexTT5 or the latest MultiMAX. Toggle Pre-Trigger on and off remotely with the MultiMAX. Required for remote camera triggering with a FlexTT5 if using E-TTL functions.
NOTE: An older mono motor drive cable and/or pre-release cable can be used instead of an -ACC cable with a FlexTT5 but you will not have E-TTL capability.

This cable contains a pre-trigger connection. When a remote zone is enabled on a MultiMAX, the camera behaves as if the camera's shutter release button were held half-pressed continuously. This makes the camera respond more quickly and consistently, but also consumes the camera's batteries much more quickly. When the remote zone is disabled, the camera will enter its normal sleep modes.